#8 x .610/.580 Int / Ext Tooth Lockwasher Low Carbon Steel Zinc Plated

Description

PICTURES ARE REPRESENTATIVE OF ITEM,  BUT ARE NOT OF THE ACTUAL ITEM.
Product dimensions, finish, head markings, thread length, stamping shape or forging shape, etc., may differ from picture. Products are guaranteed to meet the specs to which they are manufactured. Specs allow for tolerances in dimension and shape, which can vary from lot to lot.
Please read the specifications in the table below before buying. If you have any questions, or if your requirements include specific dimensions, please contact us before buying
.
Don't see what you need? Only a small portion of our inventory is listed on eBay. Please call or contact us through eBay messages with your requirements. We respond to email quickly, and in most cases are able to make a listing with the part you need, in the quantity you need, in minutes!
PRODUCT SPECIFICATIONS
Part #:
0000-100286
Fastener Type:
Internal / External Tooth Lockwasher
Size Description:
#8 x .610/.580
Diameter/Nominal Size:
#8*
Inside Diameter:
0.168-0.176"
Outside Diameter:
0.494-0.506"
Thickness:
0.023-0.028"
System of Measurement:
Inch
Grade:
2
Material:
Low Carbon Steel
Finish:
Zinc Plated
Used with:
Bolts/Screws up to Grade 5
Average Piece Weight:
0.0003000 lbs.
*Washer Sizing:
Washer sizes are nominal (sized for the bolt that the washer will fit).
Actual inside diameter is almost always larger than stated size.
Please see the Inside Diameter spec in the table above, if available.
Washers are thin disk-shaped plates with a hole that is used to distribute the load of a threaded fastener such as a bolt or nut; often have an outer diameter (OD) about twice their inner diameter (ID), but this can vary based upon the washer. Washers come in many different varieties; flat washers, split lock washers, toothed lock washers, beveled washers in both steel and iron, etc.
For Customer Service
Please Call or Contact Us Through eBay Messaging